No Security; Figure 26 Network > Wireless Lan > General; Table 10 Network > Wireless Lan > General - ZyXEL Communications PLA-450 User Manual

Chapter 4 Wireless LAN
Figure 26 Network > Wireless LAN > General
The following table describes the general wireless LAN labels in this screen.
Table 10 Network > Wireless LAN > General
LABEL
Enable
Wireless LAN
Name(SSID)
Hide SSID
Channel
Selection
Operating
Channel
Apply
Reset
See the rest of this chapter for information on the other labels in this screen.

4.5.1 No Security

Select No Security to allow wireless stations to communicate with the access points without
any data encryption.
If you do not enable any wireless security on your ZyXEL Device, your network
is accessible to any wireless networking device that is within range.
54
DESCRIPTION
Click the check box to activate wireless LAN.
(Service Set IDentity) The SSID identifies the Service Set with which a wireless
station is associated. Wireless stations associating to the access point (AP) must
have the same SSID. Enter a descriptive name (up to 32 printable 7-bit ASCII
characters) for the wireless LAN.
Select this check box to hide the SSID in the outgoing beacon frame so a station
cannot obtain the SSID through scanning using a site survey tool.
Set the operating frequency/channel depending on your particular region.
Select a channel from the drop-down list box. The options vary depending on the
IEEE 802.11 mode you are using and the country you are in.
Refer to Appendix E on page 139
This displays the channel the ZyXEL Device is currently using.
Click Apply to save your changes back to the ZyXEL Device.
Click Reset to reload the previous configuration for this screen.
for more information on channels.
PLA-450 User's Guide