Wireless Troubleshooting; Homeplug Av Troubleshooting - ZyXEL Communications PLA-450 User Manual

To reset the ZyXEL Device,
1 Make sure the PWR LED is on and not blinking.
2 ress and hold the RESET button for five to ten seconds. Release the RESET button
P
when the PWR LED begins to blink. The default settings have been restored.
If the ZyXEL Device restarts automatically, wait for the ZyXEL Device to finish restarting,
and log in to the web configurator. The password is "1234".
If the ZyXEL Device does not restart automatically,
Device's power. Then, follow the directions above again.

11.5 Wireless Troubleshooting

I cannot access the ZyXEL Device or ping any computer from the WLAN.
1 Make sure the wireless LAN is enabled on the ZyXEL Device
2 Make sure the wireless adapter on the wireless station is working properly.
3 Make sure the wireless adapter installed on your computer is IEEE 802.11 compatible
and supports the same wireless standard as the ZyXEL Device.
4 Make sure your computer (with a wireless adapter installed) is within the transmission
range of the ZyXEL Device.
5 Check that both the ZyXEL Device and your wireless station are using the same wireless
and wireless security settings.
• See the chapter on Wireless LAN in the User's Guide for more information.

11.6 HomePlug AV Troubleshooting

I cannot start my power line device.
Check your power supply is working. Power line adapters operate from the power supplied by
your home wiring and cannot operate without a working power supply. Remove the power line
adapter from the outlet. Then connect an electrical device that you know works into the same
power outlet. This checks the status of the power outlet.
I cannot access my power line network
1 Make sure that the network password is the same on all the power line adapters in your
network.
PLA-450 User's Guide
Chapter 11 Troubleshooting
sconnect and reconnect the ZyXEL
di
.
101