This chapter describes the front panel and rear panel of the switch and shows you how to make
the hardware connections.
3.1 Front Panel Connection
The figure below shows the front panel of the switch.
Figure 9 Front Panel
The following table describes the port labels on the front panel.
Table 1 Front Panel
LABEL
CONSOLE
24 10/100/
1000 Mbps
RJ-45 Gigabit
Ethernet
Ports
Gigabit/mini-
GBIC ports
3.1.1 Console Port
For local management, you can use a computer with terminal emulation software configured
to the following parameters:
• VT100 terminal emulation
• 9600 bps
• No parity, 8 data bits, 1 stop bit
• No flow control
Chapter 3 Hardware Overview
Hardware Overview
DESCRIPTION
Only connect this port if you want to configure the switch using the command line
interface (CLI) via the console port.
Connect these ports to a computer, a hub, an Ethernet switch or router.
For Gigabit uplink.
C
H A P T E R
GS-4024 User's Guide
3
43