Hardware Installation And Connection; Freestanding Installation; Figure 6 Attaching Rubber Feet - ZyXEL Communications ES-3124 User Manual

Es-3124 series intelligent layer 2+ switch
Hide thumbs Also See for ES-3124:
Table of Contents

Advertisement

Hardware Installation and
This chapter shows you how to install and connect the switch.

2.1 Freestanding Installation

1 Make sure the switch is clean and dry.
2 Set the switch on a smooth, level surface strong enough to support the weight of the
switch and the connected cables. Make sure there is a power outlet nearby.
3 Make sure there is enough clearance around the switch to allow air circulation and the
attachment of cables and the power cord.
4 Remove the adhesive backing from the rubber feet.
5 Attach the rubber feet to each corner on the bottom of the switch. These rubber feet help
protect the switch from shock or vibration and ensure space between devices when
stacking.
Figure 6
Attaching Rubber Feet
Note: Do NOT block the ventilation holes. Leave space between devices when
stacking.
For proper ventilation, allow at least 4 inches (10 cm) of clearance at the front
and 3.4 inches (8 cm) at the back of the switch. This is especially important for
enclosed rack installations.
Chapter 2 Hardware Installation and Connection
ES-3124 Series User's Guide
C
H A P T E R
Connection
2
43

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Es-3124f

Table of Contents