ZyXEL Communications ES-3124 User Manual page 157

Table 42 Classifier (continued)
LABEL
Layer 2
Specify the fields below to configure a layer 2 classifier.
VLAN
Priority
Ethernet
Type
Source
MAC
Address
Port
Destination
MAC
Address
Layer 3
Specify the fields below to configure a layer 3 classifier.
DSCP
IP
Protocol
Source
IP
Address/
Address
Prefix
Socket
Number
Destination
IP
Address/
Address
Prefix
Socket
Number
Chapter 18 Classifier
DESCRIPTION
Select Any to classify traffic from any VLAN or select the second option and specify the
source VLAN ID in the field provided.
Select Any to classify traffic from any priority level or select the second option and specify
a priority level in the field provided.
Select an Ethernet type or select Other and enter the Ethernet type number in
hexadecimal value. Refer to
Select Any to apply the rule to all MAC addresses.
To specify a source, select the second choice and type a MAC address in valid MAC
address format (six hexadecimal character pairs).
Type the port number to which the rule should be applied. You may choose one port only
or all ports (Any).
Select Any to apply the rule to all MAC addresses.
To specify a destination, select the second choice and type a MAC address in valid MAC
address format (six hexadecimal character pairs).
Select Any to classify traffic from any DSCP or select the second option and specify a
DSCP (DiffServ Code Point) number between 0 and 63 in the field provided.
Select an IP protocol type or select Other and enter the protocol number in decimal value.
Refer to Table 45 on page 159
You may select Establish Only for TCP protocol type. This means that the switch will pick
out the packets that are sent to establish TCP connections.
Enter a source IP address in dotted decimal notation.
Specify the address prefix by entering the number of ones in the subnet mask.
Note: You must select either UDP or TCP in the IP Protocol field before
you configure the socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second
option and enter a TCP/UDP protocol port number.
Enter a destination IP address in dotted decimal notation.
Specify the address prefix by entering the number of ones in the subnet mask.
Note: You must select either UDP or TCP in the IP Protocol field before
you configure the socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second
option and enter a TCP/UDP protocol port number.
Table 44 on page 158 for information.
for more information.
ES-3124 Series User's Guide
157