Figure 27-1 Tagged Vlan Configuration And Activation Example; Figure 27-2 Cpu Vlan Configuration And Activation Example - ZyXEL Communications Dimension ES-3024 User Manual

Ethernet switch
Hide thumbs Also See for Dimension ES-3024:
Table of Contents

Advertisement

Dimension ES-3024 Ethernet Switch
The following procedure shows you how to configure tagged VLAN.
Use the IEEE 802.1Q tagged VLAN commands to configure tagged VLAN for the switch.
Step 1.
Use the
sys sw vlan1q svlan setentry
switch.
Use the
sys sw vlan1q svlan active
the last step).
Use the
sys sw vlan1q port defaultVID command
that specific port in the PVID table.
Use the
sys sw vlan1q svlan active
Example:
ES-3024> sys sw vlan1q svlan setentry up1 2000 24 fixed tag
for newly create VLAN, please use svlan active <VID> to activate this entry
ES-3024> sys sw vlan1q port defaultVID 24 2000
ES-3024> sys sw vlan1q svlan setentry up1 2001 25 fixed untag
for newly create VLAN, please use svlan active <VID> to activate this entry
ES-3024> sys sw vlan1q port defaultVID 25 2001
ES-3024> sys sw vlan1q svlan active 2000
ES-3024> sys sw vlan1q svlan active 2001

Figure 27-1 Tagged VLAN Configuration and Activation Example

Configure your management VLAN.
Step 2.
Use the
sys sw vlan1q svlan setentry
for managing the switch (the "management" or "CPU" VLAN).
Use the
sys sw vlan1q svlan active
Example:
ES-3024> sys sw vlan1q svlan setentry example 3 24 fixed tag
ES-3024> sys sw vlan1q svlan active 3

Figure 27-2 CPU VLAN Configuration and Activation Example

Perform the procedure below to complete the VLAN setup.
Step 3.
a. Telnet to the operational IP address of the switch.
b. Use the
c. Use the
Example:
27-2
sys sw vlan1q svlan cpu
sys sw svlan delentry
command to configure a VLAN ID for each port on the
command when you are finished configuring the VLAN (see
to set the VLAN ID you created for a port to
command to activate the VLAN IDs.
command to configure a VLAN ID (VID 3 in this example)
command to activate the new management VLAN ID.
command to set VID 3 as the management VLAN.
command to remove the default VLAN ID (1).
IEEE 802.1Q Tagged VLAN

Advertisement

Table of Contents
loading

Table of Contents