Chapter 9 Filtering; Introduction To Filtering; Configuring A Filtering Rule - ZyXEL Communications Dimension ES-3024 User Manual

9.1 Introduction to Filtering

Port filtering means sifting traffic from one or all ports to one or all ports based on the source and/or destination
MAC addresses and VLAN group (ID).
9.1.1 Note About Configuration
The following rules apply when configuring filtering.
• The rule applies to traffic flowing in both directions if both a source and destination are specified.
• The rule applies to traffic flowing in one direction if either a source or destination is specified.
• No any-to-any rules are allowed. That is, you cannot select Ignore for both the source and destination ports.
• No blank rules are allowed. If you do not select Ignore, you must set the related fields.
• You can forward a MAC address to one port or all ports (All Ports) but not two different ports.

9.2 Configuring a Filtering Rule

Click Filtering to display the screen as shown next.
Filtering
This chapter discusses static IP and MAC address port filtering.
Dimension ES-3024 Ethernet Switch
Chapter 9
Filtering
9-1