Table 25-4 Command Summary: Ip - ZyXEL Communications Dimension ES-3024 User Manual

25.2.4 ip Commands
ip
address
alias
aliasdis
arp
httpd
icmp
ifconfig
ping
route
status
udp
tcp
Introduction to CLI

Table 25-4 Command Summary: ip

COMMAND
[addr]
<iface>
<0|1>
status
debug [on|off]
status
discovery <iface> [on|off]
[iface] [ipaddr] [broadcast
<addr> |mtu <value>|dynamic]
<hostid>
status
add <dest addr>[/<bits>]
<gateway> [<metric>]
addiface <dest addr>[/<bits>]
<iface> [<metric>]
addprivate <dest
addr>[/<bits>] <gateway>
[<metric>]
drop <host addr> [/<bits>]
status
ceiling [value]
floor [value]
irtt [value]
Dimension ES-3024 Ethernet Switch
DESCRIPTION
Displays the host IP address.
Sets an alias for the specified
interface.
Disables/enables the alias for the
specified interface.
Displays all interfaces' IP Address
Resolution Protocol status.
Enables or disables the HTTP
debug flag.
Displays the ICMP statistics
counter.
Sets the ICMP router discovery
flag.
Configures a network interface.
Pings a remote host.
Displays the routing table.
Adds a route.
Adds an entry to the routing table
for the specified interface.
Adds a private route.
Drops a route.
Displays IP statistic counters.
Displays the UDP status.
Sets the TCP maximum round trip
time.
Sets the TCP minimum round trip
time.
Sets the TCP default initial round
trip time.
25-15