VES-1124 User's Guide
26.3 Configuring Tagged VLAN
The following procedure shows you how to configure tagged VLAN.
Use the IEEE 802.1Q tagged VLAN commands to configure tagged VLAN for the switch.
1.
•
Use the
sys sw vlan1q svlan setentry
switch.
•
Use the
sys sw vlan1q svlan active
the last step).
•
Use the
sys sw vlan1q port defaultVID command
that specific port in the PVID table.
•
Use the
sys sw vlan1q svlan active
Example:
VES-1124> sys sw vlan1q svlan setentry upl 2000 24 fixed tag
for newly create VLAN, please use svlan active <VID> to activate this entry
VES-1124> sys sw vlan1q port defaultVID 24 2000
VES-1124> sys sw vlan1q svlan setentry upl 2001 25 fixed untag
for newly create VLAN, please use svlan active <VID> to activate this entry
VES-1124> sys sw vlan1q port defaultVID 25 2001
VES-1124> sys sw vlan1q svlan active 2000
VES-1124> sys sw vlan1q svlan active 2001
Figure 26-1 Tagged VLAN Configuration and Activation Example
Configure your management VLAN.
2.
•
Use the
sys sw vlan1q svlan setentry
for managing the switch (the "management" or "CPU" VLAN).
•
Use the
sys sw vlan1q svlan active
Example:
VES-1124> sys sw vlan1q svlan setentry example 3 24 fixed tag
for newly create VLAN, please use svlan active <VID> to activate this entry
VES-1124> sys sw vlan1q svlan active 3
Figure 26-2 CPU VLAN Configuration and Activation Example
Perform the procedure below to complete the VLAN setup.
3.
a. Telnet to the operational IP address of the switch.
b. Use the
c. Use the
Example:
26-2
sys sw vlan1q svlan cpu
sys sw svlan delentry
command to configure a VLAN ID for each port on the
command when you are finished configuring the VLAN (see
to set the VLAN ID you created for a port to
command to activate the VLAN IDs.
command to configure a VLAN ID (VID 3 in this example)
command to activate the new management VLAN ID.
command to set VID 3 as the management VLAN.
command to remove the default VLAN ID (1).
IEEE 802.1Q Tagged VLAN