Chapter 25 Introduction To Cli; Command Line Interface Overview - ZyXEL Communications Dimension ES-3024 User Manual

This chapter introduces line commands and gives a summary of commands available.

25.1 Command Line Interface Overview

In addition to the web configurator, you can use line commands to configure the switch. It is recommended that
you use the web configurator for everyday management of the switch and that you use line commands for
advanced switch diagnosis and troubleshooting. If you have problems with your switch, customer support may
request that you issue some of these commands to assist them in troubleshooting.
You can use the "config save" command to save 802.1Q, STP, Cluster and IP configuration
changes to non-volatile memory (Flash). These changes are effective after you restart the
However you cannot use "config save" for all other line command configurations. These are
saved in volatile memory (DRAM), so are not effective after you restart the switch.
25.1.1 Accessing the Command Line Interface
There are two ways to access the command line interface on the ES-3024:
•
Telnet to the switch
•
Connect a computer to the console port and use terminal emulation software configured to the following
parameters:
25.1.2 Command Conventions
The system uses a one-level command structure. You must type the full command every time, as follows.
192.168.1.1> <command>
For instance, the following example shows how to enable GVRP.
192.168.1.1> sys sw gvrp enable
The conventions for typing in most CI commands are shown next.
command <interface|device> subcommand [parameter]
command subcommand [parameter]
Introduction to CLI
VT100 terminal emulation
No parity, 8 data bits, 1 stop bit
Type all commands as displayed on the screen.
Dimension ES-3024 Ethernet Switch
Introduction to CLI
switch.
9600 bps
No flow control
Chapter 25
25-1