Configuring Dhcp Global Relay - ZyXEL Communications MES3500-24F User Manual

Chapter 36 DHCP

36.3.2 Configuring DHCP Global Relay

Configure global DHCP relay in the DHCP Relay screen. Click IP Application > DHCP in the
navigation panel and click the Global link to display the screen as shown.
Figure 160 IP Application > DHCP > Global
The following table describes the labels in this screen.
Table 114 IP Application > DHCP > Global
LABEL
Active
Remote DHCP
Server 1 .. 3
Relay Agent
Information
Information
Apply
Cancel
278
DESCRIPTION
Select this check box to enable DHCP relay.
Enter the IP address of a DHCP server in dotted decimal notation.
Select the Option 82 check box to have the Switch add information (slot number, port
number and VLAN ID) to client DHCP requests that it relays to a DHCP server.
This read-only field displays the system name you configure in the General Setup screen.
Select the check box for the Switch to add the system name to the client DHCP requests that
it relays to a DHCP server.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
MES3500-24/24F User's Guide