Link Aggregation Control Protocol - ZyXEL Communications XS1920 Series User Manual

Table 64 Advanced Application > Link Aggregation > Link Aggregation Setting (continued)
LABEL
Group
Apply
Cancel

17.4 Link Aggregation Control Protocol

Click Advanced Application > Link Aggregation > Link Aggregation Setting > LACP to
display the screen shown next. See
dynamic link aggregation.
Figure 105 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
Chapter 17 Link Aggregation
DESCRIPTION
Select the trunk group to which a port belongs.
Note: When you enable the port security feature on the Switch and configure port security
settings for a port, you cannot include the port in an active trunk group.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Dynamic Link Aggregation on page 148
XS1920 Series User's Guide
152
for more information on