ADF Web HD67679-IP-A1 User Manual page 26

Industrial Electronic Devices
Note:
When you install a new version of the software, if it is the first time it is better you do the update of the Firmware in the HD67679
device.
Note:
When you receive the device, for the first time, you also have to update the Firmware in the HD67679 device.
Warning:
If Fig. 7 appears when you try to do the Update try these points before seeking
assistance:
Try to repeat the operations for the updating;
Try with another PC;
Try to restart the PC;
Check the LAN settings;
Check the Wi-Fi settings;
If you are using the program inside a Virtual Machine, try to use in the main Operating System;
If you are using Windows Seven, Vista, 8 or 10 make sure that you have the administrator privileges;
In case you have to program more than one device, using the "UDP Update", you have to cancel the ARP table every time you
connect a new device on Ethernet. For do this you have to launch the "Command Prompt" and write the command "arp -d". Pay
attention that with Windows Vista, Seven, 8, 10 you have to launch the "Command Prompt" with Administrator Rights;
Pay attention at Firewall lock.
In the case of HD67679 you have to use the software "SW67679": www.adfweb.com\download\filefold\SW67679.zip.
ADFweb.com S.r.l.
User Manual BACnet slave/ PROFINET
Document code: MN67679_ENG Revision 1.011
Figure 7: "Protection" window
Page 26 of 31