OPT7 AURA Manual

MAIN COMPONENTS

INSTALLATION

1. Decide where to locate the light strips and ensure wiring has enough length for control box to be installed in desired location.
   
   EXAMPLES
   
   
   Connecting more than 6 AMP/12 V will override the kit and cause early failure, it must be power to a 6 AMP/12 V or less. You will need a voltage reducer if your battery is more than 12V.
   We provide multiple sets of extension wires for you to configure. You may connect or customize to extend them wherever you want to install.
   # AUX WIRING FOR A BRAKE LIGHT
   This feature will activate when the aux wiring is connected to the trigger wire for positive(+) wire of brake light.
   NOTE
   The default color is "RED" so that when you apply the brake, it will also sync with the brake light.
2. Secure Control box in desired location with Velcro or zipties.
   * CONTROL BOX NOT WATERPROOF
   Ensure the control box is safely and securely hidden from exposing elements of moisture.
   
3. Secure the light strips using the zip ties to tie all the wiring away from the moving components.
   
   
   The LED connectors are not waterproof. You will need to use HEAT SHRINK TUBE or ELECTRICAL TAPE around the LED connectors to ensure the longevity of the lighting kit.
4. Using the included E-Z Remote or Keychain Remote to select your desired color or pattern.
   
   1. ON/OFF
   2. Color Selector
      Supports 16 sets of solid color changes
   3. Dimmer Up/Down
      Supports 4 levels of brightness adjustment
   4. Disable

OPTIONAL UPGRADE

Upgrade your Aura Original Control Box to the Aura Pro Bluetooth Control Box. All new AURA Pro Bluetooth is App enabled by a smartphone controller (iOS & Android Compatible).