Connections To The Vx-2 And Dhd Controller; Connector Panel Access; Connecting The Dhd Controller To The Vx-2 - Runco Video Xtreme VX-2cx User Manual

Proceed as follows to connect the DHD Controller to the VX-2, your video sources,
external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
To access the connector panel, pull firmly on the cable access cover to open it.
The VX-2 is designed to receive only digital input signals directly from the companion DHD
Controller/Processor. All signal sources should be connected to the appropriate inputs on
the rear panel of the DHD. The signal from the DHD is then output to the VX-2 projector
through a Runco proprietary DVI cable.
You CANNOT connect a signal source with DVI output directly to
Note
the VX-2. It MUST be routed through the DHD Controller for proper
operation.
Use the supplied cable to connect the DVI Output of the DHD Controller to the DHD Input
of the VX-2; see Figure 3-8.
Runco International
Union City, CA
Model
OUTPUTS
Pr Y Pb
R G B
Video Processor / Controller
H V H/V DVI Out
Figure 3-8. Connecting the VX-2 to the DHD Controller
Runco VX-2cx/VX-2dcx Owner's Operating Manual
VX-2 DIGITAL PROJECTOR
INPUTS
Pr Y Pb
R G B H V
HD1
HD2
R G B H
V
Pr Y Pb
SDI
Pb Pr
DVI 1 DVI 2 Option Component Video
ON / OFF
AC IN
120V 60HZ
SYSTEM CONTROL INTERFACE
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
TRIGGERS
CAUTION:
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE CENTER.
1 2 3 IR
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
Y S-Video 1
100-230VAC 50-60 Hz, 165 Watts Max
Video S-Video 2 RS-232 Out RS-232 Control
29
3.6
Connections to the
VX-2 and DHD
Controller

Connector Panel Access

Connecting the DHD
Controller to the VX-2
!
Made In USA
Installation