Runco Video Xtreme VX-2cx User Manual page 52

Installation
Item Number
6 X-Adjustment Plate
7 Screw, Slide Head
8 Pitch Adjustment Lever, Female
9 Y-Adjustment Lever, Male
10a Yaw/X-Adjustment Lever, Female
10b Z-Adjustment Lever, Female
11 Screw, Countersink
12 Carriage Plate (CineWide with AutoScope) or Base Plate
(Fixed CineWide, not shown)
13 Washer, Fiber #10
14 Washer, Fiber
15 Lens Motor
16 Anamorphic Lens
1. Remove the two, Female Z-Adjustment Levers (item #10b) and 1/4-20 Fiber Washers
(item #14) from the Z-Adjustment Plate (item #5).
2. Place the Lens Mounting Assembly on top of (or under, if the projector is inverted) the
Lens Motor Carriage Plate or Base Plate (item #12), so that the two threaded posts at
the bottom of the Z-Adjustment Plate pass through the corresponding slots on the
carriage plate or base plate.
3. Secure the Lens Mounting Assembly to the plate with the Z-Adjustment Levers and
Washers that you removed in Step 1.
4. Place the Anamorphic Lens (item #16) inside the Lens Ring (item #1). Using a 1/4" hex
wrench, tighten the two Nylon Set Screws (item #2) on the Lens Ring to secure the
lens in place.
If this is an AutoScope installation, leave enough space between
Note
the projector and the lens mounting assembly to allow the lens to
move out of the light path without the assembly coming into
contact with the projector front jewelry.
Description
1/4-20
40 Runco VX-2cx/VX-2dcx Owner's Operating Manual
Quantity
1
2
2
2
2
2
4
1
6
2
1
1