Connecting An External Ir Receiver To The Dhd Controller; Connecting To Ac Power; External Ir Receiver Connection - Runco Video Xtreme VX-2cx User Manual

Installation
Connecting an External IR
Receiver to the DHD
Controller

Connecting to AC Power

➤
If infrared signals from the remote control cannot reach the DHD Controller due to
excessive distance or obstructions such as walls or cabinet doors, you can connect an
external IR receiver to the DHD Controller to extend the range of the remote control. See
Figure 3-15.
IR Receiver
Remote
Control
Figure 3-15. External IR Receiver Connection
Note
➤
Projector/DHD Controller: Plug the female end of one power cord into the AC
receptacle on the rear of the VX-2 (AC 100V ~ 240V). Then, connect the other end to your
AC power source.
Similarly connect the DHD Controller to a nearby AC outlet.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to a 110 VAC power
source.
Caution
SYSTEM CONTROL INTERFACE
TRIGGERS
IR
1 2 3
WARNING:
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
S-Video 1
Video S-Video 2 RS-232 Out RS-232 Control
Ring = +5V
Tip = IR Input
Sleeve = Ground
(3.5-mm
mini phono
plug)
When an external IR receiver is connected to the wired IR input, the
built-in IR sensor on the DHD Controller is disabled.
The input voltage to the AutoScope lens motor must be between
100 and 120 VAC. Do not connect the AutoScope lens motor
to a 200-240 VAC power source!
36 Runco VX-2cx/VX-2dcx Owner's Operating Manual
CAUTION
!
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
CAUTION:
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE CENTER.
100-230VAC 50-60 Hz, 165 Watts Max
Made In USA