Configure Lens Motor Trigger (Cinewide With Autoscope) - Runco Video Xtreme VX-2cx User Manual

Figure 3-18. VX-2 with AutoScope Lens Motor and Lens Mounting Assembly
CineWide with AutoScope maintains constant image height independent of the aspect
ratio, while using the full display resolution of the projector. It accomplishes this by moving
the anamorphic lens in front of the primary lens when widescreen material is being viewed.
When the viewer transitions back to 16:9 or 4:3 source material, the anamorphic lens
moves out of the light path.
To configure the lens motor trigger on the DHD Controller for proper AutoScope
operation:
1. Project a 2.35:1 aspect ratio test pattern or other image on the screen.
2. Press MENU on the remote control and enter the Service menu passcode.
3. Select Service from the Main menu.
4. Select Triggers from the Service menu.
5. Assign the trigger output to which the lens motor is connected to the Cinema and
Virtualwide 2.35 aspect ratios. This enables the lens motor to move the anamorphic
lens into position (in front of the primary lens) when either aspect ratio is selected.
6. To save the trigger settings, press
ENTER.
7. Select the Cinema aspect ratio to move the anamorphic lens into position, if it isn't
already. To do this, press CINEMA on the DHD Controller remote control (Figure 2-6),
or press or repeatedly with no menus visible on-screen.
Runco VX-2cx/VX-2dcx Owner's Operating Manual
repeatedly to highlight "Save." Then, press
41
Installation
Configure Lens Motor
Trigger (CineWide with
AutoScope)