Connections To The Vx-3000D And Dhd Controller; Connector Panel Access - Runco CINEWIDETM VX-3000D Installation & Operation Manual

For a floor (non-AutoScope) installation, turn
the four adjustable feet on the bottom of the
projector to adjust the projector height and/or
projection angle.
If you do tilt the projector, you may need to
apply keystone correction or vertically shift the
image using the on-screen display (OSD)
controls, to compensate. For detailed
instructions, refer to Using the On-Screen
Menus on page 61.
Proceed as follows to connect the DHD Controller to the VX-3000d, your video sources,
external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
To access the connector panel, pull
firmly on the cable access cover to
open it.
VX-3000d Series Installation/Operation Manual 39
Installation
3.7
Connections to the
VX-3000d and DHD
Controller

Connector Panel Access