Ricoh Aficio SPC222SF User Manual page 251

Ricoh aficio spc222sf: user guide
Hide thumbs Also See for Aficio SPC222SF:
Table of Contents

Advertisement

Message
No Profile Exist
On board memory check error An error was detected in the
Out of Memory Press Clear
Key
Outer Jam
Paper size X illegal on X
Paper size X mismatch on X
Paper size X not supported by
duplex
Paper Tray Misfeed Jam
Paper type X illegal on X
Paper type X mismatch on X
Paper type X not supported
by duplex
Please Reboot System
Print overrun
Causes
No Quick Dial entry is associ-
ated with the One Touch but-
ton you pressed.
machine's memory.
A scanned file could not be
sent because there is not
enough memory.
Paper has been jammed in the
machine.
The tray does not support
printing on the selected paper
size.
The paper size set for the doc-
ument differs from the size of
the paper in the tray.
Duplex printing is not possi-
ble on the selected paper size.
Paper has been jammed in the
paper tray.
The tray does not support
printing on the selected paper
type.
The paper type set for the doc-
ument differs from the type of
the paper in the tray.
Duplex printing is not possi-
ble on the selected type of pa-
per.
An error occurred and the ma-
chine cannot continue to oper-
ate.
The print data could not be
processed.
Error and Status Messages on the Screen
Solutions
• Press a different One
Touch button.
• Assign a registered desti-
nation to the One Touch
button. See p.120 "Regis-
tering Scan Destinations".
Contact your sales or service
representative.
Specify a lower resolution,
and then try the operation
again. See p.130 "Specifying
resolution".
Remove the jammed paper.
See p.222 "Removing Printing
Jams".
Select a supported paper size,
or load the paper into a differ-
ent tray.
Load paper of the selected size
in the tray, or change the pa-
per size setting. See p.82
"Specifying Paper Type and
Paper Size".
Load paper of a different size
in the tray, or select a different
tray.
Remove the jammed paper.
See p.222 "Removing Printing
Jams".
Select a supported paper type,
or load the paper into a differ-
ent tray.
Load paper of the selected
type in the tray, or change the
paper type setting. See p.82
"Specifying Paper Type and
Paper Size".
Load paper of a different type
in the tray, or select a different
tray.
Turn off the power, and then
turn it back on.
Print the job again from a
higher performance comput-
er.
9
243

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aficio spc221sfSp c220sSp c221sfSp c222sf

Table of Contents