Panasonic Lumix DMC-G2 Operating Instructions Manual page 191

[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE
WRITING SPEED OF THE CARD]
•
Use a card with SD Speed Class
[AVCHD Lite].
Also, use a card with SD Speed Class with "Class 6" or higher when recording motion pictures
in [MOTION JPEG].
¢ SD Speed Class is the speed standard regarding continuous writing.
• In the event that it stops even after using a "Class 4" card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format (P39).
•
Depending on the type of the card, motion picture recording may stop in the middle.
[THIS CARD IS NOT FORMATTED WITH THIS CAMERA, AND NOT SUITABLE FOR
MOVIE RECORDING.]
•
The writing speed is lower if the card has been formatted using a PC or other equipment. As a
consequence, motion picture recording may stop in the middle. If this happens, make a
backup of the data and format (P39) the card in this unit.
[A FOLDER CANNOT BE CREATED]
•
A folder cannot be created because there are no remaining folder numbers that can be used.
(P172)
> Format the card after saving necessary data on a PC etc. (P39) If you execute
[NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100.
(P39)
[PICTURE IS DISPLAYED FOR 16:9 TV]/[PICTURE IS DISPLAYED FOR 4:3 TV]
•
The AV cable is connected to the camera.
> Press [MENU/SET] if you want to delete this message at once.
> Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect. (P37)
•
This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P171,
173)
[NO BATTERY POWER REMAINS]
•
The remaining battery power is low.
> Charge the battery.
[THIS BATTERY CANNOT BE USED]
•
The battery cannot be recognized by the camera.
> Use a genuine Panasonic battery. If this message is displayed even when a genuine
Panasonic battery is used, contact the dealer or your nearest Service Center.
•
The battery cannot be recognized as its terminal is dirty.
> Remove any dirt etc. from the terminal.
[PLEASE MAKE SURE TO TURN ON THE POWER OF EXTERNAL MICROPHONE.]
•
When attaching the stereo microphone (DMW-MS1; optional), check the battery status and
make sure the power is on before use. (P180)
¢
with "Class 4" or higher when recording motion pictures in
Others
191
VQT2S30