Advanced (Playback)
Note
•
The number of prints can be set from 0 to 999.
•
With a printer supporting PictBridge, the date print settings of the printer may take precedence
so check if this is the case.
•
It may not be possible to use the print settings with other equipment. In this case, cancel all the
settings, and reset the settings.
•
If the file is not based on the DCF standard, the print setting cannot be set.
•
[PRINT SET] cannot be set for motion pictures recorded in [AVCHD Lite] and pictures that were
taken with the [QUALITY] set to [
You can set protection for pictures you do not want to be deleted by mistake.
Select [PROTECT] on the [PLAYBACK] Mode menu. (P32)
Press 3/4 to select [SINGLE] or [MULTI] and then
press [MENU/SET].
Select the picture, and then
press [MENU/SET].
When [MULTI] has been selected
•
Repeat these steps for each picture.
•
The settings are canceled when
[MENU/SET] is pressed again.
Press [‚] to return to the menu screen.
•
Press [MENU/SET] to close the menu.
∫ Canceling all the [PROTECT] settings
1
Select [CANCEL] on the screen shown in step
2
Press 3 to select [YES] and then press [MENU/SET].
3
Press [MENU/SET] to close the menu.
•
If you press [MENU/SET] while canceling protection, the canceling will stop halfway.
Note
•
The protect setting may not be effective on other equipment.
•
Even if you protect pictures on a card, they will be deleted if the card is formatted.
•
Even if you do not protect pictures on a card, they cannot be deleted when the card's
Write-Protect switch is set to [LOCK].
160
VQT2S30
].
P [PROTECT]
[SINGLE]
Press 2/1 to select
the picture.
2
[MULTI]
Press 3/4/2/1 to
select the pictures.
and then press [MENU/SET].