Fault Codes - DCS DishDrawer DD124 Series Use & Care Manual

FAULT CODES

HOW TO RECOGNIZE A FAULT CODE
When a fault has occurred, the DishDrawer® will continuously beep every second.
Each fault code is shown in the following chart.
HOW TO ATTEND TO A FAULT CODE
Press the button to remove the fault code.
1
If the fault code and continuous beeps cannot be removed by pressing the
2
turn the power off at the power supply.
We recommend you check the following chart and correct the fault where possible.
3
After attending to the fault, turn the DishDrawer® on at the power supply.
4
If the fault code and continuous beeps remain, turn the water and power supply off to
5
the DishDrawer®.
When calling your Authorized Service Center advise them of the fault code that has
6
appeared on the DishDrawer®. This information will help the Authorized Service
Center respond to your request.
FAULT CODES
F1
F2
F3
F4
F9
U1
POSSIBLE CAUSES
Flood switch has been
activated.
Motor problem.
Temperature sensor failed.
Faulty temperature sensor
or element
Electronics malfunction.
Fill Fault
WHAT TO DO
Turn the water and power supply to the
®
DishDrawer off and call your Authorized
Service Center.
Call your Authorized Service Center.
1 Ensure water coming in through the
inlet hose is not hotter than 65
may need to install a tempering valve
on your water supply.
2 Call your Authorized Service Center.
Call your Authorized Service Center.
Call your Authorized Service Center.
1 Turn the DishDrawer® water supply
on.
2 Ensure the spray arm can rotate about
the center, and if the DishDrawer®
is full of water, it will need to be
emptied manually.
3 Call your Authorized Service Center.
button,
o
C. You
25