Installation Checklist - DCS DishDrawer DD124 Series Use & Care Manual

INSTALLATION CHECKLIST

Your installer MUST have completed and checked the following:
®
The DishDrawer is square and level.
®
The DishDrawer is fastened securely to the cabinetry.
Ensure moisture protection tape has been applied and the cabinet is sealed according
to the DishDrawer
®
The DishDrawer opens and closes freely. The DishDrawer
completely with no resistance from cabinetry.
For the integrated models, check the
place.
The power supply is connected and switched on.
The inlet water hose is connected and turned on. There should be no leaks.
The drain hose(s) are connected and there are no leaks. There must be no kinks, or
obstructions in the drain hose(s).
The spray arm is in the center and can freely rotate.
The rinse program has been run.
The water level will be below the stainless steel filter plate at the end of the wash
program. It is normal to find some water in the drain filter area.
Set the water softener to the correct water hardness for your area (DD224-H, DD124-H
models only).
Important!
The installer is responsible for the DishDrawer® installation. Incorrect installation is
not covered by warranty.
®
Installation Instructions.
5
/ " air gap has been achieved in the correct
16
®
must be free to close