DCS DishDrawer DD124 Series Use & Care Manual page 30

PROBLEM
DishDrawer®
interior is
stained
Foaming
No detergent
dispensed
Excessive
motor noise
Water leaking
DishDrawer®
will not open
24
POSSIBLE CAUSE
Some foods, like tomato
based products, may
stain the inside of the
DishDrawer®.
Incorrect amount of
detergent.
Too much egg in the
wash load.
Rinse agent setting too
high.
Detergent was wet
when loaded.
The filter plate and/or
spray arm is incorrectly
placed.
No water in the motor
area.
Drain hose
disconnected from
waste pipe.
Supply inlet hose not
properly connected.
Other leaks.
Childlock function is on
or the Closed Drawer
option is on, or both.
WHAT TO DO
Pre-rinse dishes before placing
in the DishDrawer®. Alternatively,
using the Rinse program after
adding the dishes may minimize
staining.
Refer to the detergent section
or consult the detergent
manufacturer's instructions.
Increase the amount of detergent.
Decrease the rinse agent setting.
Clean the dispenser and ensure
the dispenser is dry when adding
detergent.
Refer to the user maintenance
section for details on correct
placement.
This usually occurs on the first use
or when the DishDrawer® has not
been used for long periods of time.
Run the DishDrawer® through a
wash program.
Reconnect the drain hose to the
waste pipe.
Ensure the inlet hose is connected
securely.
Turn water and power supplies
to the DishDrawer® off. Call your
dealer or Authorized Service Agent.
Turn the Lock function off. Hold
down the button until the light
above the button disappears and/or
press the button to open the
DishDrawer®.