Trouble Shooting - DCS DishDrawer DD124 Series Use & Care Manual

TROUBLE SHOOTING

PROBLEM
Continuous
beeping
Intermittent
beeping
DishDrawer®
will not start
Excess
water in the
DishDrawer®
Water marks on
the dishes
Dishes did not
dry
22
POSSIBLE CAUSE
A fault has occured.
DishDrawer® is in pause
mode.
Power supply is not
connected.
The drawer is not
properly closed.
Lock feature is on.
button not pressed. Press the
Drain hose(s) bent or
kinked.
Blocked filters and/or
drain hose(s).
Insufficient rinse agent.
Rinse agent setting too
low.
DishDrawer®
overloaded/incorrectly
loaded.
Insufficient or no salt
in the water softener
(DD224-H, DD124-H
models only)
Incorrect loading.
Rinse agent depleted.
Rinse agent setting too
low.
Eco wash program used. Choose a standard wash program.
WHAT TO DO
Refer to the Fault codes section.
Close the DishDrawer® and press
the button.
Connect the power supply.
Ensure the drawer is firmly closed.
Turn the Lock off. Hold down the
button until the light above the
button disappears.
button.
Straighten the drain hose(s).
Clean the filter plate/drain
filter. Unblock the drain
hose(s). Refer to the user
maintenance section.
Ensure there is enough rinse agent
in the dispenser.
Increase the rinse agent setting.
Refer to the section on loading.
Ensure there is enough salt in the
water softener and/or increase the
water softener setting.
Ensure the dishes are not nesting
together.
Refill the rinse agent dispenser.
Increase the rinse agent setting.