Numark 5000FX Quick Start Owner's Manual page 9

Toggle: Adjusts the rate of the CHOP
effect based upon the BPM 1 setting
Wheel: Moving the wheel clockwise
makes the gaps in the music longer.
Moving the wheel counter-clockwise
makes the gaps in the music shorter.
Display 2: Shows the fractions of the
gap based on beats of the music.
• ECHO: This creates a repeating echo in
the music. To stop the music and still
hear the echo tail off, flip the input
selector switch. To use this effect,
BPM1 should be set to the current BPM.
Toggle: Adjusts the rate of the echo
based upon the BPM1 setting.
Wheel: Moving the wheel clockwise
inreases the echo time. Moving the wheel
counter-clockwise makes the echo in the
music shorter.
Display 2: Shows the fractions of the beat
of the echo delay time.
• DELAY: This effect delays the music in time
from the original source. To use this effect,
BPM1 should be set to the current BPM.
Toggle: Adjusts the delay time based upon
the BPM1 setting
Wheel: Moving the wheel clockwise
increases the delay time. Moving the wheel
counter-clockwise makes the delay shorter.
Display 2: Shows the fractions of the beat
of the delay time.
Wet/Dry slider: This fades from source
audio to delayed audio. This effect can be
used to create the same double beat effect
often used by DJs when 2 of the same song
are mixed with the beats offset.
• FILTER: This effect is used to filter out
frequencies of the audio.
Toggle: Adjusts the point of frequency
removal from 150 (low), vocal (mid), and
high. The toggle alternates between 3
modes: "ISO" for the isolate effect, "kIL"
for the kill effect, and "vOC" for the vocal
kill effect. For ISO, the parameter shows
the deviation of the bandpass center
frequency from mid-range. For kIL, this
parameter indicates the deviation of the
band reject center frequency from mid-
range. For vOC, this parameter indicates
the cutoff frequency of the low-pass filtered
audio added back to the vocal killed audio.
Wheel: Fine tunes the filter frequency.
Display 2: Shows the frequency of the
music eliminated.
• PITCH (Channel 1- Master Processing
Mode): Adjusts the pitch or Key of the
audio source.
Toggle: Adjusts the pitch by one musical
half-step at a time.
Wheel: Fine tunes the pitch.
Display 2: Shows amount of pitch
adjustment.
• PITCH (Sampler Processing Mode):
This effect adjusts the pitch and tempo of
the sampler.
Toggle: Selects the type of adjustment
desired.
• SLD is a key-slide effect that
smoothly changes the pitch of the
music without changing the tempo.
• PIT changes both the pitch (key) of
the music and tempo at the same
time.
• LOC changes only the tempo of
the music without changing the
key. This effect is known as
Key Lock.
Wheel: Fine-tunes these adjustments.
Display 1: Shows the BPM of the
sampler
Display 2: Shows the amount of
tempo or key change.
• DISTORT: This effect creates
distortion from the audio source.
Wheel: Moving the wheel clockwise
increases the effect. Moving the wheel
counter-clockwise decreases the effect.
Toggle: No Function
Display 2: Shows the level of this
effect.
9