Feature Operation; Australia Etsi; Description - Nortel Meridian Meridian 1 Feature Description And Administration

Page 846 of 1814
LD 73 – Define the frame format and grade of service timers for a PRI/PRI2 loop.
Prompt Response
REQ CHG
TYPE PRI
PRI2
FEAT LPTI
LOOP xxx
MFF (AFF)
CRC
ACRC (NO)
YES
ALRM (REG)
ALT
RAIE (NO)
YES
...
PERS 0-(50)-256
CLEA 0-(50)-256

Feature operation

Australia ETSI

Description

553-2901-301 Standard 9.00 January 2002
ISDN PRI Central Office Connectivity
Description
Change existing data.
PRI loop.
PRI2 loop.
Set the timers for PRI2 loop.
PRI/PRI2 loop number.
Alternate frame format (default).
CRC-4 frame format.
NO = No automatic reporting of CRC-4 errors during
transmission.
Automatic reporting of CRC-4 errors during transmission.
Regular mode of firmware alarm version (default).
Alternate mode of firmware alarm version.
Disable RAIE Group II alarm state (default).
Enable RAIE Group II alarm state.
Persistence timer for Group II problems (2 ms increments).
Clearance timer for Group II problems (2 ms increments).
No operating procedures are required to use this feature.
The Australia ETSI feature supports 2.0 Mb ISDN Primary Rate Interface and
Basic Rate Interface Trunk connectivity for the Australian Central Office, in
compliance with the Australia ETSI specification (Telstra).