Trox Technik X-CUBE X2 compact 2 Operating Instructions Manual page 10

Safety
Dangers when handling the AHU > General workplace hazards
1.6 Work areas and hazardous areas
Fig. 6: Hazardous areas
Work areas
Hazardous area
Areas from which you can access
fans

electric air heaters

integral switch cabinets

are hazardous areas. You can access these hazardous areas only after you open an inspection access door.
Before installation is complete, open air inlets and outlets are also considered hazardous areas.
1.7 Dangers when handling the AHU
The air handling unit is a state-of-the-art product
and meets current safety requirements. Residual risks
cannot be excluded, however, and you should proceed
with caution. This section describes the residual risks
that have been identified in a risk assessment.
Always follow the safety notes in this manual to reduce
health hazards and prevent any hazardous situations.
10
1.7.1 General workplace hazards
Working at height
WARNING!
Risk of a fall when you work at height!
Working at height without using any fall protection
equipment, or using unsuitable or damaged equip-
ment to get up to where you work at height, may lead
to yourself or others falling from height; people on
the ground may be at risk from falling parts or tools.
This can cause serious or even fatal injuries.
– Wear a safety harness.
– Only access roofs with suitable and intact fall
protection equipment in place (ladders, railings,
safety harness).
– Start working only if the components you have to
work on are easily accessible.
– Stop materials or objects from falling.
– Wear safety shoes, protective clothing and a
hard hat.
AHU X-CUBE X2 compact 2