Advertisement
Quick Links
Advertisement
Related Manuals for Precor Resolute Multi-Stations Triceps Pushdown Station
Summary of Contents for Precor Resolute Multi-Stations Triceps Pushdown Station
- Page 1 ENGLISH Resolute™ Multi-Stations Triceps Pushdown Station Assembly Guide...
-
Page 2: Assembly Requirements
4. Weight stack assembly (if applicable) Trademarks 5. Finish all stations and route cables (where applicable) Resolute is a trademark and Precor is a registered trademark of Peloton Interactive, Inc. 6. Stabilization arms or hooks All other trademarks belong to their respective owners. - Page 3 SHCS M6 x 10 mm Weight stack spacer 152 mm (for standard weight stack) Washer 13 mm Add on weight (5 lbs/2.3 kg) Top shroud plate, Precor logo Add on weight selector handle Top shroud corner cover Tension rope handles...
-
Page 4: Tower Assembly
Tower Assembly Triceps Top Frame Assembly (use Triceps Parts List) IMPORTANT The Triceps Pushdown Station can ONLY be installed on a Quad Tower. Place the triceps top frame on top of the tower. Ensure the pins rest inside the top Quad Tower Frame Assembly (use Quad Tower Parts Lists) of the columns and the holes align. - Page 5 Figure 8. Triceps heavy weight stack Figure 7. Triceps standard weight stack Slide the weights (20 for standard, 28 for heavy) onto the guide rods, followed by the top weight plate (Figure 9). Figure 5. (This figure is an example. Your top frames may look different based on the stations added to tower.) QUAD TOWER ONLY Repeat the above weight stack procedure for the other stations attached to the quad tower (refer to their assembly guides).
- Page 6 Route the Cable Place a guide rod retaining spring into a guide rod cap over the rods. Press down on the cap and snap each rod into place in the holes of the top frame (Figure Unfurl the cable at the top pulley. Remove the 11).
- Page 7 Stabilizing arms are required in most configurations. If the tower will be bolted Attach the top shroud Precor plate to the top frame and secure it with to the floor, then stabilizing arms are not required. Angled storage hooks are M8 x 20 mm SHCS (from the Quad Tower parts list) (Figure 19).
-
Page 8: Complete The Assembly
Standards can be changed or updated. Precor recommends that you keep apprised of your local industry standards. Precor shall not be liable for failure to properly secure and bolt strength equipment to the floor.
Need help?
Do you have a question about the Resolute Multi-Stations Triceps Pushdown Station and is the answer not in the manual?
Questions and answers