Set The Service Port Ip; Configure Failover (For Dual Controller Device) - UNIVIEW IPSAN Series Quick Manual

3.4 Set the Service Port IP

1. Choose System Configuration > System Maintenance > Network Configuration.
Select the service port,then click Add.
2. Change the service port IP to 100.1.1.91 (configure this according to the actual
situation).
NOTE!

The default IP addresses of the service ports are empty.

If expansion boards are inserted, the corresponding default IP addresses are
empty too.
3. Click Confirm.

3.5 Configure Failover (For Dual Controller Device)

1. Choose Failover Settings > Configure.
Change the IP Address
Configure Failover Settings
17