Table of Contents
Advertisement
Handling your camera system
74
1.
Set the power dial to single shot, continuous, or—for advanced settings—the red dot.
Note: If you set the power dial to the red dot for advanced settings, set exposure bracketing, focus
bracketing, the self-timer, or to shoot continuously with the mirror locked up.
2.
Briefly push the shutter release button to prepare the camera for use.
The handgrip display turns on. The indicator light on the top of the imaging module turns orange
and then starts to blink. After a short time, it turns green and the imaging module beeps. The imaging
module display turns on, and the message Ready to Shoot appears. The camera system is now ready
to use.
Note: If the camera system is not used for three minutes, it automatically enters sleep mode. You can
set the amount of time after which the camera enters sleep mode. To activate the camera from sleep
mode, briefly push the shutter release button.
Turning off the camera system
Turn off the camera system when not in use to conserve the battery power.
Turn the power dial to OFF.
The camera and imaging module turn off.
Note: When using a split supply solution, turning the power dial to OFF does not turn off the imaging
module. Turn off the imaging module by pushing the imaging module power button.
Advertisement
Table of Contents
