Datamax Allegro 2 Operator's Manual page 30

Other Switches
Switch SW-5: Controls the label edge offset, when the switch is on,
Switch SW-6: Present Sensor Option
Switch SW-7: Enables the Internal Batch Software Program. This
Switch SW-8: Controls the optional Cutter.
SW-5
On
Off
SW-6
On
Off
SW-7
On
Off
SW-8
On
Off
Table 2-4 Switch Settings and Functions
22
Setting Up Your Printer
the label edge offset will default to 0250. When the
switch is off, the label edge offset will default to 0220.
program is explained in Chapter 3. There is a software
command that will perform the same option as this
switch; it is the STX g Command.
Prodigy Compatibility
Prodigy
Allegro
Present Sensor Option
Present Sensor Enabled
Present Sensor Disabled
Internal Batch Software
Internal Batch Enabled
Internal Batch Disabled
Cutter
Cutter Enabled
Cutter Disabled
Allegro2