Download Print this page

Voltage Specification - Flash EVENT washRING600 User Manual

Advertisement

Available languages

Available languages

User Manual • Instrukcja Obsługi
DMX
Controller

5.2 Voltage specification

Input Voltage
100~240V AC
5.3 Connecting power supply
The connection is performed using
power cable with PowerCon connector
( i n c l u d e d ) . T h e d e v i c e m u s t b e
operated by qualified personnel.
5.5 Set DMX Address Code
1. Press „Menu"(Home) to „Set DMX
Address", and press „ENTER" keys to
enter into.
2. Show „Set DMX Address DMX Address:
001", Press the „UP and DOWN" keys to
amended.
DMX 512
CAUTION! In the case of cable damage do not attempt to repair.
Replacement or repair can be made only on the manufacturer or by
a person with appropriate permissions.
Using lamp, the change rate of power voltage should be within
±10%, if the voltage is too high, it will shorten the light's life; if it's not
enough, the lamp will be dark. Please restart it after turning off light
for 20 minutes until full-cooling. Frequent switching will reduce the
life span of lamps and bulbs; intermittent using will improve the life
of bulbs and lamps.
Total Power
480W
Make sure that the power grid supply
parameters are consistent with device
parameters and limitations are not exceeded.
3. Press „ENTER" keys to save and Exit,
Press the „MENU" (Home) Keys does not
save and Exit.
DMX 512
Frequency
50/60Hz
120Ω

Advertisement

loading
Need help?

Need help?

Do you have a question about the EVENT washRING600 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

F7100772