FMS FCX24 DPFMS12403PRORTRR Instruction Manual page 4

Safety Precautions
• Interference may cause loss of control. To ensure the safety of you and others, do not operate in the
following places:
1、Near any site where other radio control activity may occur
2、Near power lines or communication broadcasting antennas
3、Near people or roads
4、On any body of water when passenger boats are present
• Do not use this product when you are tired, uncomfortable, or under the influence of alcohol or drugs.
Doing so may cause serious injury to yourself or others.
• The 2.4GHz radio band is limited to line of sight. Always keep your model in sight as a large object can
block the RF signal and lead to loss of control.
• Do not touch any part of the model that may generate heat during operation, or immediately after use.
The engine, motor or speed control, may be very hot and can ause serious burns.
•请不要在夜晚或雷雨天气使用本产品，恶劣的天气环境有可能导致遥控设备失灵。
•请不要在能见度有限的情况下使用本产品。
•请不要在雨雪或有水的地方使用本产品。如果有液体进入到系统内部，可能会导致运行不稳定或失灵。
•信号干扰可能导致设备失控。为保证您和他人的安全，请不要在以下地点使用本产品：
1、通信基站附近或其他无线电活跃的地方
2、人多的地方或道路附近
3、水域附近
4、高压电线或通信广播天线附近
•当您感到疲倦、不舒服，或在摄入酒精或服食导致麻醉或兴奋的药物后，不要操作本产品。否则可能对自己或
他人造成严重的伤害。
•2.4GHz无线电波段完全不同于之前所使用的低频无线电波段。使用时请确保模型产品在您的视线范围内，大的
障碍物将会阻断无线电频率信号从而导致遥控失灵模型失控。
•请勿在操作过程中或使用后立即触摸模型可能产生热量的任何部分。发动机、电机或速度控制器可能非常热，
并可能导致严重烧伤。
• Misuse of this product may lead to serious injury or death. To ensure the safety of you and your
equipment, read this manual and follow the instructions.
• Make sure the product is properly installed in your model. Failure to do so may result in serious injury.
• Make sure to disconnect the receiver battery before turning off the transmitter. Failure to do so may
lead to unintended operation and cause an accident.
• Ensure that all servos operate in the correct direction. If not, adjust the direction first.
• Make sure the model stays within the systems maximum range to prevent loss of control.
•遥控设备使用不恰当可能导致操作者或他人严重受伤，甚至死亡。为保证您和设备的安全，请仔细阅读使用说
明书并按照要求进行操作。
•使用前必须确保本产品与模型安装正确，否则可能导致模型发生严重损坏。
•关闭时，请务必先关闭接收机电源，然后关闭发射机。如果关闭发射机电源时接收机仍然在工作，将有可能导
致遥控设备失控或者引擎继续工作而引发事故。
•操控时，请先确认模型所有舵机的动作方向与操控方向一致。如果不一致，请调整好正确的方向。
•当遥控距离较远时，有发生失控的可能，请适当缩短遥控距离。
安全保障措施
强制
Mandatory
4