Table of Contents
Advertisement
FS728TP Smart Switch FS728TP Smart Switch Software Administration Manual
Work Area – Located on the right side of the NETGEAR FS728TP web browser interface and
marked as 3 in Figure 2-2. The Work Area contains device tables, general device information, and
configurable device parameters.
For further description of the functions, refer to the appropriate section of this manual:
•
Chapter 3, "Managing System Settings"
•
Chapter 4, "Configuring Switching Settings"
•
Chapter 5, "Configuring QoS"
•
Chapter 6, "Managing Security"
•
Chapter 7, "Monitoring the Switch"
•
Chapter 8, "Maintenance"
•
Chapter 9, "Online Help"
Using the NETGEAR Web Management System Options
The FS728TP web browser interface provides the following options:
•
Device Management Buttons – Provides an explanation of the management buttons in the
NETGEAR FS728TP Smart Switch.
•
Informational Services – Provides access to informational services including technical
support, online help and device information.
•
Using Screen and Table Options – Provides an explanation of specific GUI characteristics
and tables for configuring the device.
Device Management Buttons
The NETGEAR FS728TP Smart Switch web browser GUI management buttons allow network
managers to easily configure the device from remote locations. The management buttons are
shown below:
Table 2-1. Device Management Buttons
Button Name
Add
Apply
CANCEL
Introduction to the Web Browser Interface
describes how to configure the System functions.
describes how to configure the Switch functions.
describes how to configure QoS functions.
describes how to configure security.
describes how to configure monitoring functions.
describes maintenance functions, such as firmware upgrade.
describes how to obtain online help and support.
Description
Adds information to tables or information windows.
Applies configured changes to the device.
Cancels modifications to tables or information windows.
v1.0, December 2007
2-3
Advertisement
Table of Contents
