Table of Contents
Advertisement
FS728TP Smart Switch FS728TP Smart Switch Software Administration Manual
•
Port Speed – Select the data transmission rate for the port. The port type determines
which speed setting options are available. Port speeds can only be configured when auto
negotiation is disabled. The possible field values are:
–
10M – The port is currently operating at 10 Mbps.
–
100M – The port is currently operating at 100 Mbps.
–
1000M – The port is currently operating at 1000 Mbps.
•
Duplex Mode – Select the port duplex mode. This field is configurable only when auto
negotiation is disabled and the port speed is set to 10M or 100M. The possible field values
are:
–
Half – The interface supports transmission between the device and the client in only
one direction at a time.
–
Full – The interface supports transmission between the device and its link partner in
both directions simultaneously.
–
Auto – The interface supports transmission between the device and the link partner
based on the transmission mode of the link partner.
•
Auto Negotiation – Select the port auto negotiation status. Auto negotiation is a protocol
between two link partners that enables a port to advertise its transmission rate, duplex
mode, and flow control abilities to its partner. The possible field values are:
–
Enable – Auto negotiation is enabled.
–
Disable – Auto negotiation is disabled.
•
Back Pressure – Select the back pressure mode of the Port. Back Pressure mode is used
with half duplex mode to disable ports from receiving messages. Back Pressure mode is
disabled by default. The possible field values are:
–
Enable – Back pressure mode is enabled.
–
Disable – Back pressure mode is disabled.
•
Flow Control – Select the flow control status of the port. Operates when the port is in full
duplex mode. Flow control is disabled by default. The possible field values are:
–
Enable – Flow control is enabled.
–
Disable – Flow control is disabled.
Configuring Switching Settings
v1.0, December 2007
4-3
Advertisement
Table of Contents
