Table of Contents
Advertisement
FS728TP Smart Switch FS728TP Smart Switch Software Administration Manual
CST Port Configuration
To configure CST ports on the device:
1. Click Switching > STP > Advanced > CST Port Configuration. The CST Port
Configuration screen displays:
Figure 4-19
The CST Port Configuration screen contains the following fields:
•
Interface – Displays the port or LAG for which the STP information is displayed.
•
STP Status – Select the STP status on the interface. The possible field values are:
–
Enable – Enable STP on the interface.
–
Disable – Disable STP on the interface.
•
Fast Link – Select the Fast Link state on the interface. If Fast Link mode is enabled for a
interface, the Port State is automatically placed in the Forwarding state when the port link
is up. Fast Link optimizes the STP protocol convergence. The possible field values are:
–
Enable – Enable Fast Link on the interface.
–
Disable – Disable Fast Link on the interface.
Configuring Switching Settings
v1.0, December 2007
4-27
Advertisement
Table of Contents
