Table of Contents
Advertisement
FS728TP Smart Switch FS728TP Smart Switch Software Administration Manual
To configure RADIUS servers:
1. Click Security > Management Security > RADIUS. The RADIUS screen displays:
Figure 6-2
The RADIUS screen contains the following fields:
•
Host IP Address – Enter the RADIUS Server IP address.
•
Authentication Port – Enter the authentication port. The authentication port is used to
verify the RADIUS server authentication. The authenticated port default is 1812.
•
Number of Retries – Enter the number of transmitted requests sent to the RADIUS server
before a failure occurs. Possible field values are 1-10. The default value is 3.
•
Timeout for Reply – Enter the amount of time (in seconds) the device waits for an answer
from the RADIUS server before retrying the query, or switching to the next server.
Possible field values are 1-30. The default value is 3.
•
Dead Time – Enter the default amount of time (in minutes) that a RADIUS server is
bypassed for service requests. The range is 0-200. The default value is 0.
•
Key String – Enter the default key string used for authenticating and encrypting all
RADIUS-communications between the device and the RADIUS server. This key must
match the RADIUS encryption.
•
Usage Type – Select the RADIUS server authentication type. The default value is Login.
The possible field values are:
–
Login – The RADIUS server is used for authenticating user name and passwords.
–
802.1X – The RADIUS server is used for 802.1X authentication.
–
All – The RADIUS server is used for authenticating user names and passwords, and
802.1X port authentication.
Managing Security
v1.0, December 2007
6-3
Advertisement
Table of Contents
