Table of Contents
Advertisement
HAZARD AVOIDANCE
Switching between operating modes:
1) Select the Map Page Group.
2) Select the Traffic Map Page.
3) Press the STANDBY or OPERATE Softkey to switch between modes. 'TIS STANDBY' or 'TIS OPERATING' is
displayed in the status box in the upper left corner of the Traffic Map Page.
OR :
1) Press the MENU Key. The page menu displays 'Standby Mode' or 'Operate Mode'.
2) Press the ENT Key.
TRAFFIC ALERT MESSAGES
TIS P
-U
OWER
P
The G1000 performs and automatic test during power-up. If TIS passes the power-up test, the standby
screen displays on the Traffic Map Page. If the aircraft is airborne during the test, traffic displays on the
Traffic Map Page.
If TIS fails the power up test, one of the following traffic alert messages display in yellow in the center of
the screen:
• NO DATA - Data is not being received from the transponder.
• DATA FAILED - Data is being received from the transponder, but a failure was detected in the data
stream.
• FAILED - The transponder has failed.
• UNAVAILABLE - The traffic service is unavailable or out of range
Contact the service center or Garmin dealer for corrective action all of these messages, except the
UNAVAILABLE message.
6-62
T
EST
Garmin G1000 Pilot's Guide for Piper PA32
190-00692-00 Rev. B
Advertisement
Table of Contents
