Horizontal Surface Mounting - HP J4093A Installation Manual

Installing the Switch 1600M and 2424M
Installation Procedures
4.
install additional
screw

Horizontal Surface Mounting

Attach the bumper feet included in the accessory kit to the bottom of the
switch, and place the switch on a table or other horizontal surface. Use a
sturdy surface in an uncluttered area. You may want to secure the networking
cables and switch power cord to the table legs or other part of the surface
structure to help prevent people from tripping over the cords.
N o t e
Make sure the air flow is not restricted around the sides and back of the switch.
2-12
Install the other number 12-24 screw into the upper hole in each bracket.
Tighten these screws.