Gbic_Security Messages - Cisco WS-C2955T-12 Software Manual

Error Message and Recovery Procedures
Error Message GBIC_1000BASET-6-GBIC_1000BASET_NO_CONFIG_SPEED: Configuration
ignored. 1000-BaseT GBIC modules only support autonegotiation on speed.
Explanation
Recommended Action

GBIC_SECURITY Messages

This section contains the Cisco GBIC module security messages. The GBIC modules have a serial
EEPROM that contains the module serial number, the vendor name and ID, a unique security code, and
cyclic redundancy check (CRC). When the GBIC module is inserted into the switch, the software reads
the EEPROM to check the serial number and the vendor name and ID, and to recompute the security
code and CRC. The switch shuts down the interface and displays a GBIC_SECURITY error message if
the GBIC serial number, the vendor name or ID, the security code, or CRC is invalid.
Error Message GBIC_SECURITY-4-DUPLICATE_SN: GBIC interface [chars] has the same
serial number as another GBIC interface.
Explanation
matches that of another interface on the system. [chars] is the interface in which the GBIC is
installed.
Recommended Action
obtained from Cisco or a supported vendor.
Error Message GBIC_SECURITY-4-GBIC_INTERR: Internal error occurred in setup for GBIC
interface [chars].
Explanation
problem during the setup for the specified GBIC interface. [chars] is the interface in which the GBIC
is installed.
Recommended Action
problem persists, call your Cisco technical support representative.
Error Message GBIC_SECURITY-4-ID_MISMATCH: Identification check failed for GBIC
interface [chars].
Explanation
unable to verify its identity. [chars] is the interface in which the GBIC is installed.
Recommended Action
upgrade might be required for newer GBICs. Otherwise, verify that the GBIC was obtained from
Cisco or a supported vendor.
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
A-16
1000-BaseT GBIC modules only support autonegotiation on speed.
No action is required.
This message means that the GBIC was identified as a Cisco GBIC, but its serial number
Cisco GBICs are assigned unique serial numbers. Verify that the GBIC was
This message means that the system could not allocate resources or had some other
Reload the switch by using the reload privileged EXEC command. If the
This message means that the GBIC was identified as a Cisco GBIC, but the system was
Check the list of supported GBICs for this version of the system software. An
Appendix A System Messages
78-6511-08