Cisco WS-C2955T-12 Software Manual page 286

Recovery Procedures
Enter the IP address of the default gateway, and press Return.
Step 14
IP address of the default gateway: ip_address
Step 15 Enter a host name for the switch, and press Return.
Note
Enter a host name: host_name
Step 16 Enter the password of the failed command switch, and press Return.
Note
Enter enable secret: secret_password
Step 17 Enter Y to enter a Telnet password:
Would you like to configure a Telnet password? [yes] y
Note
Step 18 Enter the Telnet password, and press Return:
Enter Telnet password: telnet_password
Enter Y to configure the switch as the cluster command switch. Enter N to configure it as a member
Step 19
switch or as a standalone switch.
Note
Would you like to enable as a cluster command switch? y
Step 20 Assign a name to the cluster, and press Return.
Enter cluster name: cls_name
Note
The initial configuration is displayed:
Step 21
The following configuration command script was created:
ip subnet-zero
interface VLAN1
ip address 172.20.153.36 255.255.255.0
ip default-gateway 172.20.153.01
hostname host_name
enable secret 5 $1$M3pS$cXtAlkyR3/6Cn8/
line vty 0 15
password telnet_password
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
9-20
On a command switch, the host name is limited to 28 characters; on a member switch to 31
characters. Do not use -n, where n is a number, as the last character in a host name for any switch.
The password can be from 1 to 25 alphanumeric characters, can start with a number, is case
sensitive, allows spaces, but ignores leading spaces.
The password can be from 1 to 25 alphanumeric characters, is case sensitive, allows spaces, but
ignores leading spaces.
If you enter N, the switch appears as a candidate switch in Cluster Builder. In this case, the
message in Step 20 does not appear.
The cluster name can be 1 to 31 alphanumeric characters, dashes, or underscores.
Chapter 9 Troubleshooting
78-6511-08