Cisco WS-C2955T-12 Software Manual page 106

Planning a Switch Cluster
Discovery through CDP Hops
By using CDP, a command switch can discover switches up to seven CDP hops away (the default is
three hops) from the edge of the cluster. The edge of the cluster is where the last member switches are
connected to the cluster and to candidate switches. For example, member switches 9 and 10 in
are at the edge of the cluster.
You can set the number of hops the command switch searches for candidate and member switches by
selecting Cluster > Hop Count. When new candidate switches are added to the network, the command
switch discovers them and adds them to the list of candidate switches.
In Figure
is three. The command switch discovers switches 11, 12, 13, and 14 because they are within three hops
from the edge of the cluster. It does not discover switch 15 because it is four hops from the edge of the
cluster.
Figure 5-1
Edge of
cluster
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
5-6
5-1, the command switch has ports assigned to management VLAN 16. The CDP hop count
Discovery through CDP Hops
Command switch
Management
VLAN 16
Member
switch 8
Member
switch 9
Switch 11
candidate
switch
Management
VLAN 16
Member
switch 10
Switch 12
Candidate
Switch 13
switches
Switch 14
Switch 15
Chapter 5 Clustering Switches
Figure 5-1
78-6511-08