Cisco UBR924 - uBR 924 Router Troubleshooting Tips page 43

Table 6 Possible but Uncommon Cable Interface Reset Causes (continued)
Message
CMAC_LOG_RESET_SERVICE_NOT_AVAILABLE
CMAC_LOG_RESET_T6_RETRIES_EXHAUSTED
CMAC_LOG_RESET_MAINTENANCE_WATCHDOG_DRIVER
CMAC_LOG_RESET_NET_ACCESS_MISSING
CMAC_LOG_RESET_FAILED_WRITE_ACCESS_CONTROL
CMAC_LOG_RESET_DHCP_FAILED
CMAC_LOG_RESET_CANT_START_DS_TUNER_PRCESS
CMAC_LOG_RESET_TOO_MANY_DS_LOCKS_LOST
CMAC_LOG_RESET_NO_SEND_TO_DS_TUNER_PROCESS
CMAC_LOG_RESET_DS_TUNER_WATCHDOG
CMAC_LOG_RESET_UNABLE_TO_SET_MIB_OBJECT
CMAC_LOG_RESET_MIB_OBJECT_PROCESS_WATCHDOG
Description
The CMTS has failed the Cisco uBR924's registration
because a required or requested class of service is not
available.
The CMTS failed too many times to respond to a
REG-REQ message.
The Cisco uBR924 MAC layer failed to detect a change
in the interface driver.
The Network Access parameter is missing from the
DOCSIS configuration file.
The Cisco uBR924 was unable to set the Write Access
Control for an SNMP parameter as specified by the
DOCSIS configuration file.
The DHCP server did not respond with all the required
values. The required values are: IP address, network
mask, TFTP server IP address, TOD server IP address,
DOCSIS configuration file name, and time zone offset.
The Cisco uBR924 was unable to start the internal
process used to manage the downstream tuner.
Downstream QAM/FEC lock has been lost too many
times.
The Cisco uBR924 MAC-layer process was unable to
communicate with the downstream tuner management
process.
The downstream tuner process failed to report its
continuing operation for a long period of time.
The Cisco uBR924 was unable to set an SNMP parameter
as specified by the DOCSIS configuration file.
The internal MIB object took too long to process the
entries in the DOCSIS configuration file.
Troubleshooting Tips for the Cisco uBR924 Cable Access Router 43
show controllers cable-modem mac