Diode Dynamics Stage Series Installation Manual

Thank you for your purchase of this custom-designed bracket for your 2017-2020 Ford Raptor!
This kit utilizes both the factory and included hardware to mount the bracket to the vehicle.
Please contact us if you have any questions.
Tools Needed: 8mm, 10mm, 13mm sockets, ratchet, socket extension, 4mm Allen key
B
A
1. Using a 13mm socket, loosen
screw . Do not fully remove the
A
screw. Next, remove screw .
B
This kit provides three lighting functions: road-legal fog lights, an ambient backlight illumination, and bright off-road lighting. Using the included
wiring harnesses, you can switch between these functions with ease. The off-road lights and backlight feature are controlled manually with the
included 3-way toggle switch, or your factory auxiliary switches. When routing harnesses, avoid areas that may be subject to heat buildup or
moving parts. We recommend following the path of original manufacturer wiring harnesses.
PAGE 1
D
C
2. Using an 8mm socket, loosen
screw from the strut. Do not
C
fully remove the screw. After
that, remove screw from
D
the strut.
Wiring Instructions
SS3 Fog Light Kit Installation Guide
E
3. Slide the bracket in-between
the bumper and the support
E
Using the stock mounting points,
replace the original 13mm screw,
only hand-tightening it.
5. Tighten the screws that were hand-tightened and retighten the
screws that were loosened to secure the bracket.
6. Using the included hardware, attach your pods to the included
bracket and then attach it the base bracket on the vehicle.
See diagram to the left.
(314) 205-3033
2017-2020 Ford Raptor
4. Slide the other side of the
. bracket between the strut and
the bumper . Using the stock
F
mounting points, install the
included M6 screw, only
hand-tightening it.
See back for further instructions.
WWW.DIODEDYNAMICS.COM
F