Diode Dynamics Stage Series Installation Manual

SS6 SAE/DOT LED Lightbar Kit Installation Guide
Thank you for your purchase of this custom-designed Stage Series LED Light Bar Kit for
your 2019+ Ford Ranger! This kit utilizes both factory and included hardware to mount
the bracket to the vehicle.
Tools Needed: Flat-head screwdriver or trim removal tool, 10mm and 13mm sockets
NOTE: We recommend routing the harness before installing the light bar, as it will be difficult
to access the harness once the light is installed.
PAGE 1
2019+ Ford Ranger
1. If applicable, remove the license plate holder. To do
so, remove the two 10mm screws along the bottom of
the holder. Then using a trim removal tool or flat-head
screwdriver, pry up on the two mounting clips located
on the top of the holder to remove it from the vehicle.
Set it aside.
2. Using a trim removal tool or flat-head screwdriver,
remove the five plastic push-rivets from along the top
of the lower grille opening.
NOTE: The center push-rivet will be reused.
3. Route your wiring harness. We recommend routing
the harness across the front of the engine bay and
down the front passenger side corner to the lower
grille area. This will require the core-support trim panel
to be removed. It is held in place with four plastic
push-rivets and two screws on the intake.
(314) 205-3033
See back for further instructions.
WWW.DIODEDYNAMICS.COM