Diode Dynamics STAGE Series Mounting Manual

Thank you for your purchase of our new SS3 Type SD Foglight Kit. CAD-designed to use existing mounting points,
this kit is compatible with the 2011-2016 Ford F-250/F-350. Basic installation instructions are included below.
Please contact us if you have any questions.
1. Remove the metal brace to gain access to
the foglight bracket assembly. Use a 13mm
socket and ratchet to remove the four bolts
shown above.
4. Remove the adjustment aiming screw using
an 8mm socket.
The adjustment screw, spring, and plastic
clip will be reused.
7. Install the Type SD bracket onto the factory
foglight bracket, by reinstalling the plastic
push rivets.
PAGE 1
2. With the metal brace removed you can
remove the entire foglight bracket assembly
by removing the three 8mm bolts
shown above.
5. Remove the two plastic push rivets
shown above that secure the OEM lamp onto
the foglight bracket using a trim removal tool
(or flat head screw driver).
These will be reused as well.
8. Reinstall the adjustment screw, spring, and
plastic clip to the bottom of the bracket.
SS
3
Type SD Foglight Kit
3. Set the foglight bracket assembly on a table.
Remove the four metal retaining washers
using a pick or flathead screw driver. Then
remove the four 13mm nuts that secure the
front bezel to the foglight bracket.
These parts will be reused.
6. Using the included hardware, attach the
Type SD bracket to the pod. See the diagram
above and make sure the bracket is in the
correct orientation. Tighten the bolts down.
Do not overtighten or use power tools to
torque them down.
NOTE: The 3rd mounting point will be
used for aiming.
9. Reattach the front bezel using the four
13mm nuts. Do not over tighten.
See back for further instructions.
(314) 205-3033 WWW.DIODEDYNAMICS.COM
3" LED Pod