General Information; Intended Use Of The User Manual; General Safety Information - HMS Networks Intesis IN770AIR00SO000 User Manual

General Information

3. General Information

3.1. Intended Use of the User Manual

This manual contains the main features of this Intesis gateway and the instructions for its appropriate
installation, configuration, and operation.
Any person who installs, configures, or operates this gateway or any associated equipment should be aware of
this manual's contents.
Keep this manual for future reference during the installation, configuration, and operation.

3.2. General Safety Information

IMPORTANT
Follow these instructions carefully. Improper work may seriously harm your health and damage the
gateway and/or any other equipment connected to it.
Only technical personnel, following these instructions and the country legislation for installing electrical
equipment, can install and manipulate this gateway.
Install this gateway indoors, in a restricted access location, avoiding exposure to direct solar radiation, water, high
relative humidity, or dust.
Preferably, mount this gateway on a DIN rail inside a grounded metallic cabinet, following the instructions in this
manual.
If mounting on a wall, firmly fix this gateway on a non-vibrating surface, following the instructions in this manual.
All wires (for communication and power supply, if needed) must only be connected to networks with indoor
wiring. All communication ports are considered for indoor use and must only be connected to SELV circuits.
Disconnect all systems from power before manipulating and connecting them to the gateway.
Use SELV-rated NEC class 2 or limited power source (LPS) power supply.
CAUTION
To avoid earth loops that can damage the gateway and/or any other equipment connected to it, we
strongly recommend:
• The use of DC power supplies, floating or with the negative terminal connected to earth. Never
use a DC power supply with a positive terminal connected to earth.
• The use of AC power supplies only if they are floating and not powering any other device.
Use a circuit breaker between the gateway and the power supply. Rating: 250 V, 6 A.
Supply the correct voltage to power the gateway. The admitted range is detailed in the technical specifications
table.
Respect the expected polarity of power and communication cables when connecting them to the gateway.
USER MANUAL Version 1.0.12
700series Air Gateway - IN770AIR⁎⁎⁎O000
Page 3 of 50