Cable Information - NEC MultiSync M431-2 User Manual

4. Connect the supplied power cord
NOTE: Please make sure that enough power is supplied to the monitor. Please refer to the "Power Supply" in the


specification (See
page 71).

5. Cable information

CAUTION: Use the provided specified cables with this product so as not to interfere with radio and television reception.


For USB, please use a shielded signal cable with ferrite core.
For HDMI, RS-232C and DisplayPort, please use a shielded signal cable.
Use of other cables and adapters may cause interference with radio and television reception.
6. Turn on the power for the monitor and the external equipment
Switch on the monitor power first.
7. Operate the attached external equipment
Select the input source for the attached equipment to show the image signal on screen.
NOTE:
Under the conditions below, DDC communication is disabled.


•
Turning off the monitor's main power.
•
When [MODE] in [POWER SAVING SETTINGS] has been set to [LOW POWER] in the OSD menu, and the
monitor is turned off or shift to the power saving mode.
8. Adjust the sound
Make volume adjustments when required.
9. Adjust the picture settings (see page 78)
If necessary, make adjustments to the backlight, colors, contrast, and image position in the OSD PICTURE menu.
"M431-2" on page 68, "M501-2" on page
Screw
Clamp
69, "M551-2" on page 70
English−11
and "M651-2" on